2,7A charging. 12/24V. With Easy-switching system. With vibration dampeners.
An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior! You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter to the Molex connector for additional features. 12/24 Volt. The product is E-approved. Connect the power cable with a 3 A fuse. 3 A charger. Professional installation recommended. The rubber vibration dampeners help to eliminate vibrations when mounted onto a vehicle operating in rough road conditions. You have full access to all buttons and outlets when the device is in the holder. The charging device connects to the unit automatically when you put the unit in the holder.
Made of high grade black ABS/Acetal plastic. Made in Sweden. Connect the power cable with a 3A fuse. Professional installation recommended. Attach onto a Pedestal Mount.
Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.
Please read all of the instructions and look at the pictures before attaching the holder.
1. Place the holder onto the desired position and screw into place with the enclosed screws.
2. To place the device in the holder: Place the lowerpart of the device into the holder. Press the device downward into place in the holder.
3. To remove the device from the holder: Push the decvice uppward. When the device is set free, lift it upward out of the holder.
4. The holder is in place.
Also Suitable for: